🔧 Справочник мастера
ГлавнаяHome › ДеталиParts

Муфта отжима (clutch / splutch)Spin clutch (clutch / splutch)

Spin clutch (clutch / splutch) · clutch assembly, splutch, clutch band, clutch shoes, drive pulley and splutch, муфта сцепления

Что это и где стоитWhat it is and where

Муфта (clutch) у top-load даёт корзине плавно разогнаться до оборотов отжима и связывает/разъединяет корзину и привод.

  • Старые Whirlpool/Kenmore direct drive: муфта с фрикционными колодками/лентой (clutch shoes/band) на коробке передач под баком; при износе отжим медленный.
  • Whirlpool/Maytag VMW, Cabrio, Bravos: «splutch» (spline + clutch) — узел над шкивом снизу машины: шлицевой зацеп, который актуатор (shift actuator) переключает между стиркой и отжимом.
  • GE top-load: узел муфты и тормоза (clutch / brake) снизу на коробке.
  • Samsung top-load: узел муфты (clutch assembly) с мотором муфты.

У front-load муфты нет — барабан крутит мотор напрямую или через ремень.

On a top-load the clutch lets the basket ramp up to spin speed and couples/uncouples the basket and the drive.

  • Old Whirlpool/Kenmore direct drive: a clutch with friction shoes/band on the transmission under the tub; when worn, spin is slow.
  • Whirlpool/Maytag VMW, Cabrio, Bravos: the "splutch" (spline + clutch) — the assembly above the pulley underneath: a splined coupler the shift actuator moves between wash and spin.
  • GE top-load: clutch and brake assembly under the gearcase.
  • Samsung top-load: a clutch assembly with a clutch motor.

Front-loads have no clutch — the motor turns the drum directly or via a belt.

Признаки поломкиSymptoms when it fails

📏 Как проверитьHow to test

ПриборMeter

Мультиметр не нужен — механическая проверка (кроме мотора муфты у Samsung — Ω по tech sheet).

No meter — mechanical check (except the Samsung clutch motor — Ω per tech sheet).

✅ НормаNormal

Шлицы с чёткими гранями, корпус splutch целый; колодки/лента с запасом накладки, без масла.

Splines crisp, splutch housing intact; shoes/band with lining left, no oil.

❌ НеисправнаFaulty

Сорванные/скруглённые шлицы, треснувший корпус, стёртые или замасленные накладки — замена муфты (у VMW — комплект splutch). Если сорваны шлицы на валу привода — проверить вал/коробку тоже.

Stripped/rounded splines, cracked housing, worn or oily linings — replace the clutch (on VMW — the splutch kit). If the drive shaft splines are damaged, check the shaft/gearcase too.

  1. Обесточить. Пустая корзина должна проворачиваться рукой, а при отжиме разгоняться за несколько секунд.

    Unplug. The empty basket should turn by hand and reach speed within seconds in spin.

  2. Исключить простое: ремень (VMW), муфта мотора (old DD), актуатор переключения (VMW) в сервисном тесте.

    Rule out the simple stuff: belt (VMW), motor coupling (old DD), shift actuator (VMW) in the service test.

  3. VMW: положить машину на перед, снять кожух, ремень и шкив (гайка 13 мм), осмотреть шлицы шестерни и корпус splutch.

    VMW: lay the washer on its front, remove cover, belt and pulley (13 mm nut), inspect the gear splines and the splutch housing.

  4. Old direct drive: снять мотор и коробку, осмотреть колодки/ленту муфты на износ и замасливание.

    Old direct drive: remove motor and gearcase, inspect the clutch shoes/band for wear and oil.

🔧 ЗаменаReplacement

  • Whirlpool VMW (splutch): обесточить, положить машину на перед; снять кожух шкива, ремень, гайку шкива 13 мм (удерживать шкив), шкив, шестерню корзины; повернуть корпус splutch и снять; осмотреть шлицы вала; поставить новый комплект, собрать. Прогнать калибровку.
  • Old Whirlpool DD: снять корпус, мотор, насос, агитатор, гайку вала; открутить 3 болта коробки снизу, снять коробку, снять муфту/ленту, поставить новую, собрать.
  • Whirlpool VMW (splutch): unplug, lay the washer on its front; remove the pulley cover, belt, 13 mm pulley nut (hold the pulley), pulley, basket drive gear; twist off the splutch housing; inspect shaft splines; fit the new kit, reassemble. Run calibration.
  • Old Whirlpool DD: remove cabinet, motor, pump, agitator, shaft nut; remove the 3 gearcase bolts underneath, drop the gearcase, replace the clutch/band, reassemble.

💰 Детали и стоимостьParts & cost (ориентир наestimate as of 2026-10)

ОригиналOEMМуфта (splutch) Whirlpool/Maytag VMW (оригинал)Whirlpool/Maytag VMW pulley clutch kit (OEM)
W10721967
$23–$40
КомплектKitНеоригинальная муфта VMW / с ремнёмAftermarket VMW clutch kit / with belt
W10006384
$14–$35
ОригиналOEMМуфта в сборе Samsung (оригинал)Samsung clutch assembly (OEM)
DC97-16984A
$160–$300

На VMW splutch дешёвый, работа ~1 ч; заодно поменять ремень (W10006384) и проверить актуатор. Муфты Samsung и GE в 5–10 раз дороже и меняются дольше (нужно снимать мотор/узел снизу).On VMW the splutch is cheap and takes ~1 h; replace the belt (W10006384) and check the actuator at the same time. Samsung and GE clutches cost 5–10× more and take longer (motor/assembly comes off underneath).

🕐 РаботаLabor: 0.75–2.5 чh × $133/чh = $100–$333
🚐 Выезд / диагностикаService call / diagnosis: $163
Итого для клиентаCustomer total: $277–$796
деталь + работа + выезд; без налога и наценки на детальpart + labor + call; before tax and parts markup

Номер детали всегда подтверждай по полной модели. Цены — ориентир, проверяй перед заказом.Always confirm the part number by full model. Prices are estimates — check before ordering.

💡 Заметки мастераTech notes

Где встречаетсяShows up in

🎬 ВидеоVideos

🛠 Пошаговые инструкции с фото (iFixit)Step-by-step photo guides (iFixit)

Источники (3)Sources (3)