How to Troubleshoot Dispenser Drawer Residue in a Tricity Bendix Washing Machine
Tricity Bendix Washing MachineModerate⏱ 10 - 15 minutes
Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».
The dispenser drawer, also called the detergent drawer or dispensing drawer, holds washing powder, detergent, and fabric conditioner before they wash into the drum. Over time, residue and gunge can build up in the drawer and wash onto clothes. Use this guide to remove, clean, and refit the drawer, clean the drawer cavity, check the drum rubber, and flush the machine for better washing results. This guide was written using a Tricity Bendix washer dryer, so other Tricity Bendix models may have minor differences.
🧰 Tools
- Shop Towels or Rags
- Brush
- Scrub Brush
- Nitrile Disposable Gloves
ШагиSteps
1
Prepare the washing machine
- Wear protective gloves if detergent residue irritates skin.
2
Locate the dispenser drawer
- Find the dispenser drawer at the top left corner of the washing machine.
- Pull the drawer straight out until it reaches the stop and will not move farther.
3
Release and remove the drawer
- Press down the release button inside the dispenser drawer.
- Keep the button pressed and pull the drawer straight out of the machine.
- Push the drawer in slightly, pull it back to the stop, and press the button again.
- Use a cloth dampened with hot, soapy water to wipe visible residue from the drawer opening if buildup is holding the drawer.
4
Clean the dispenser drawer
- Pull out the blue cover on the drawer if you want to clean underneath it.
- Scrub the drawer and blue cover in hot, soapy water with a brush.
- Remove washing powder, detergent, fabric conditioner residue, and gunge from the channels.
- Rinse away loosened residue before refitting the drawer.
5
Clean the drawer cavity
- Use a cloth and hot, soapy water to wipe inside the dispenser drawer cavity.
- Wipe only the areas you can reach without pushing tools down into the machine.
- Remove loose residue from the cavity before reinstalling the drawer.
6
Reinstall the dispenser drawer
- Align the dispenser drawer with the grooves in the drawer opening.
- Press down the release button as you slide the drawer into the machine.
- Push the drawer straight in until it sits fully home.
7
Check the drum rubber
- Open the washing machine door and inspect the rubber seal inside the drum opening.
- Check the rubber for residue, debris, and blockages.
- Use a brush or scrubbing brush to clean dirty areas of the rubber seal.
- Make sure the drainage holes in the rubber are clear.
- Remove any debris you find before running the hot wash.
8
Run an empty hot wash
- Plug the washing machine back in and close the door.
- Run an empty wash on the hottest setting.
- Use a 90 °C washing program or Drum Clean option if the machine has one.
Repeat this cleaning about every six months to keep detergent and conditioner residue from building up in the drawer, cavity, and drum rubber. Repair didn't go as planned? Ask our Answers community for help.
«How to Troubleshoot Dispenser Drawer Residue in a Tricity Bendix Washing Machine» — автор eCuration, iFixit, лицензия CC BY-NC-SA 3.0. Показано без изменений. Открыть оригинал и комментарии →