How to Reset a Maytag Top Load Washing Machine (2022-Present)

MaytagMaytag Washing MachineModerate⏱ 10 - 20 minutes

Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».

Use this procedure to reset and recalibrate a 2022-present Maytag top load washing machine after replacing a part or when the washer acts erratically (won’t spin, won’t agitate, or behaves inconsistently). A successful recalibration teaches the control how to run the motor, valves, pump, and shifting system correctly.

🧰 Tools

Screwdriver Set

ШагиSteps

Prepare the washer

Remove all towels, clothing, and objects from the washer tub.
Close the lid.
Make sure the washer is off and no indicator lights are lit near the main control dial.
Press the Power button to turn the washer off if any lights are on.
Note the number of dials and their starting positions, since some models have fewer dials.

Enter the reset recalibration code

Complete the following dial and button sequence in under six seconds.
Rotate the temperature encoder dial to its lowest position.
Press the Start or Hold to Start button.
Rotate the temperature dial one click clockwise, then press Start.
Rotate the temperature dial one click counterclockwise back to the first position, then press Start.
Rotate the temperature dial one click clockwise to the second position again, then press Start.
Listen for the lid lock to engage and look for all the indicator lights to turn on as confirmation.

Start the recalibration routine

Rotate each control dial once to advance to the next stage.
Rotate the dials in any order, but working left to right helps you keep track.
Press the Power button so all the indicator lights turn back on.
Press the Hold to Start button once.
Wait for the lid lock to unlock, then open and close the lid one time so it can relock.

Let the washer recalibrate

Watch for the indicator lights to flash in order, which signals recalibration has started.
Listen for the water valves opening and closing, the drain pump running, and the washer beginning to agitate and spin.
Let the washer run uninterrupted for about two minutes.
Keep the tub empty during recalibration or the routine may be thrown off.
Wait for the lid to unlock when the routine finishes.

Retry if the code does not work

Unplug the washer for 30 seconds to discharge the control, then plug it back in.
Confirm the temperature encoder dial matches the intended starting orientation, such as being set to the second position before you begin entering the code.
Repeat the code entry and make sure the entire sequence is completed in under six seconds.

Use the technician sheet and check the control board

Turn the washer off before accessing any internal documentation or electronics.
Remove the back panel screws and lift off the back panel to look for the technician sheet.
Look behind the control board area for the technician sheet, which may list alternate modes and model-specific recalibration information.
Plug the washer in and look for a flashing green light on the control board.
If the green light is not flashing, the washer may not be working in the first place and the control board could need replacement.
Unplug the washer again before reinstalling the back panel.

A successful reset and recalibration is confirmed by the lid lock cycling, the indicator lights flashing in sequence, and the washer running a brief routine that includes valves, pump, agitation, and spin before unlocking. If the washer still won’t calibrate, retry the sequence timing, power-cycle the washer, verify the temperature dial’s starting position, and use the technician sheet for model-specific diagnostics. Repair didn't go as planned? Ask our Answers community for help.

«How to Reset a Maytag Top Load Washing Machine (2022-Present)» — автор Ben Schlichter, iFixit, лицензия CC BY-NC-SA 3.0. Показано без изменений. Открыть оригинал и комментарии →