Amana Washing Machine NTW4516FW Motor Replacement

AmanaAmana Washing Machine NTW4516FWModerate⏱ 45 minutes - 1 hour

Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».

Here is an Amana washer that had issues with the motor. This was determined after running the automatic diagnostics. Replacement is straight forward with no pitfalls or difficulties. To work on this replacement, you will need to gain access to the bottom. It is best to place the washer on its front. Place a few old blankets etc. so as not to scratch the front to much. Since I did a total rebuild on this washer, I had also removed the control panel. It was easier for me to place the washer upside down :-)

🧰 Tools

5/16" Nut Driver
13mm Socket
3/8" Drive Ratchet

⚙️ Parts

Motor part number W10623547

ШагиSteps

Step 1

Not shown here is that you need to unplug the washer as well as disconnect the water supply hoses prior to working on it! First the pulley cover has to be removed. It is attached via two 5/16 bolts
First the pulley cover has to be removed. It is attached via two 5/16 bolts
Use an electric screwdriver with a short extension and a 5/16 socket to remove the right screw,
followed by the left screw, is easiest. A hand ratchet or a nut driver will of course work as well.

Step 2

Remove the pulley cover
Now clearly visible are motor, pulley for the drive (clutch/splutch is underneath), shift actuator and start capacitor for the motor
To remove the drive belt, lift one side up and then pulling it to the drive pulley while continuing to pull up on it. The belt will eventually run off the pulley

Step 3

Belt is now removed
The motor is held to the housing by two 13mm machine bolts
I am using a 13mm socket to remove one,

Step 4

and then the other bolt
Both bolts are identical
The motor is still boxed in the housing. Slide it to the outside

Step 5

and then lift it up. There is enough length of the electrical cable to allow for this movement.
Next is to remove the wire connector. It does use a locking tab.
Move the locking tab up (you will now see the gap (Red arrow)

Step 6

lift the locking tab with your fingernail (or a small screwdriver will work as well )
pull on the connector, (not the wire!)
until the connector comes free

Step 7

Motor can now be repalced.
Here is the tag for anybody that will need to know more about the motor.
The Calibration Cycle must be run whenever a main component i.e. main control, motor, pump etc. has been replaced. To run the cycle, use the instructions received from the seller of a replacement part. Or you can use the Tech Sheet for this washer and follow the instructions on page 4

To reassemble your device, follow these instructions in reverse order.

«Amana Washing Machine NTW4516FW Motor Replacement» — автор oldturkey03, iFixit, лицензия CC BY-NC-SA 3.0. Показано без изменений. Открыть оригинал и комментарии →