Whirlpool WED87HED Dryer Power Cord Replacement

WhirlpoolWhirlpool WED87HEDEasy⏱ 10 - 20 minutes

Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».

Use this guide to change the power cord on your Whirlpool Duet WED87HED Dryer. Sometimes the power cord can get pinched or damaged and need to be replaced, and this guide will get you through it.

🧰 Tools

5/16" Nut Driver
1/4" Nut Driver
Phillips #2 Screwdriver
6-in-1 Screwdriver

⚙️ Parts

PT220L - Whirlpool Dryer Power Cord
Whirlpool Electric Dryer Power Cord - PT600L
Whirlpool Dryer Power Cord - PT400L
PT500L - Whirlpool Dryer Power Cord

ШагиSteps

Safety Precautions

Before you begin your repair, unplug your dryer.
Your power cord may have four prongs rather than three. The additional prong is a ground connection.

Unfasten the cover plate

Use a 5/16 inch nut driver to remove the 16.2 mm-long cover plate screw.

Remove the cover plate

Remove the cover plate.

Disconnect the cord

Mark the cables with a permanent marker if needed and take a picture or draw a diagram.
Use a Phillips driver or a 1/4 inch nut driver to remove the three 21.4 mm-long screws.
If your plug has 4 prongs, there will be a ground connection from the cord as well. Use a 5/16 inch nut driver to remove this connection.

Remove the cord

Pull the cord carefully down through the round hole.
Make sure you replace the connections correctly when you reassemble.

To reassemble your device, follow these instructions in reverse order. Repair didn’t go as planned? Ask our Answers community for help.

«Whirlpool WED87HED Dryer Power Cord Replacement» — автор Bill Gilbert, iFixit, лицензия CC BY-NC-SA 3.0. Показано без изменений. Открыть оригинал и комментарии →