Electrolux LTE12 - Washing Machine Disassembly

Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».

ШагиSteps

1

Step 1

• Unplug the wall outlet.
• Release the water hose.
• Loosen the 4 Phillips screws at the top and 2 1/4 screws below.

2

Step 2

• Fasten the lid of the washing machine with a large crepe tape. Do not open when removing the top of the machine.
• There is no need to remove the glass cover to remove the top of the machine.

3

Step 3

• Open the top of the washer. Lift the back first. And then the front.
• Grip the top of the machine with care. Take care not to drop and break the cover glass.
• Release the power cord and hose clips from the pressure switch.

4

Step 4

• Remove the Phillips screw.
• Remove the two plastic fasteners.
• Remove the protective cap (semi-transparent) on the left side.

5

Step 5

• Remove the two Phillips screws.
• Remove the protective cap (semi-transparent) on the right side.

6

Step 6

• To loosen the Control Panel cover, loosen the two Phillips screws. (Left side).

7

Step 7

• To loosen the Control Panel cover, also loosen the two Phillips screws on the right side.

8

Step 8

• Carefully lift the cover of the Control Panel. In this photo, the glass cover was removed to enlarge the image.

9

Step 9

• If there is a need to replace the Power Circuit Board, carefully pull out the program select button.
• And then loosen the two Phillips screws.
• Disconnect the cables carefully.

10

Step 10

• To remove the circuit board from the Panel buttons, remove the three Phillips screws. Disconnect the cable carefully.
• When removing the circuit board from the buttons, be aware of the three button springs.

11

Step 11

• If you need to replace any components on the button circuit board, loosen the three Phillips screws to remove the acrylic shield.
• The problem with my machine was the power button. With a soldering iron and a sucker, I switched on the power switch.

12

Step 12

• To change the pressure switch, cut the clamp and remove the
• Disconnect wires.
• And then loosen the two Phillips screws.